Need welded chute assembly manual

[mikefly15]

Hello, would like to have a copy of the welded chute assembly book. I have been waiting since 9/29/20 for the item. I just want to get a head start on disassembly. About a month ago the EX4 had some wild temp swings. Wanted to cook a pizza @ 450° on a stone and it would not hold the temp. Anyway, If someone has and can upload the copy…GREAT. Good Grillin

 

[JpsBBQ]

I didn’t get any instructions with my welded chute, I’m not sure if others got any. There are a couple YouTube videos by Harry soo and trendkiller BBQ that show the process

 

[abmet]

I think I still have mine I’ll check tomorrow.

 

[abmet]

Here you go, hope this is what you were looking for. Had to split into two parts to be small enough to upload. There is also an addendum I got that is for replacing the auger steps.
Since is opens like a book, I couldn’t run though my doc scanner so had to use my phone.

 

[Alanh]

Hello, would like to have a copy of the welded chute assembly book. I have been waiting since 9/29/20 for the item. I just want to get a head start on disassembly. About a month ago the EX4 had some wild temp swings. Wanted to cook a pizza @ 450° on a stone and it would not hold the temp. Anyway, If someone has and can upload the copy…GREAT. Good Grillin

Hello, would like to have a copy of the welded chute assembly book. I have been waiting since 9/29/20 for the item. I just want to get a head start on disassembly. About a month ago the EX4 had some wild temp swings. Wanted to cook a pizza @ 450° on a stone and it would not hold the temp. Anyway, If someone has and can upload the copy…GREAT. Good Grillin

I also received the welded chute without instructions. I just emailed a request through the Weber site and Scott was quick to respond. I have not compared my recent document with other responses to your plea. Scott also sent a Weber video of the revised pellet ramp fitting .

 

[Alanh]

Hello, would like to have a copy of the welded chute assembly book. I have been waiting since 9/29/20 for the item. I just want to get a head start on disassembly. About a month ago the EX4 had some wild temp swings. Wanted to cook a pizza @ 450° on a stone and it would not hold the temp. Anyway, If someone has and can upload the copy…GREAT. Good Grillin

It's me again with a warning... when fitting the new welded auger etc, you need to note that the instructions do not mention that you should separate the chute and fit it to the grill before reassembling the motor and auger. I just completed my SmokeFire update!